Bearing and Small Parts Cleaning Kit
- USE NEW BULLET POINTS
-
· Cleaning Instructions:
1. Use the supplied tool to remove bearing retaining rings (if needed).
2. Use the supplied tool to remove bearing shields.
3. Leaving strainer inside container, place items to be cleaned inside container with solution. Tighten lid.
4. Let parts soak for 30 minutes, shaking or stirring every couple minutes to ensure a proper cleaning.
5. Open lid and lift strainer out of container, thus removing parts to be cleaned.
6. Empty newly cleaned parts onto towel.
7. If bearings were grease filled, inspect parts to see if there are any residual bits of grease that need to be brushed off using the supplied brush.
8. Using the supplied towel, wipe off and dry the parts.
9. It is suggested to use a can of compressed air to completely dry and blow out any remaining contaminants. Please use approved eye protection when performing this task.
10. Once parts are completely dry and clean they are ready for reassembly (if needed). If they are bearings, they will need to be lubricated before reassembly (see instruction number 11).
11. For best results apply Helo Light Speed Bearing Oil (follow instructions supplied with oil) to add lubrication to bearings.
12. Once lubricated, reassemble with shields and retaining rings as needed.